Welcome to download the newest Pass4itsure 300-320 dumps:

Flydumps bring you the best Cisco 642-355 exam preparation materials which will make you pass in the first attempt.And we also provide you all the Cisco 642-355 exam updates as Microsoft announces a change in its Cisco 642-355 exam syllabus,we inform you about it without delay.

QUESTION 72
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?
A. Configure OSPF routing on the IPS-8.
B. Configure EIGRP routing on the IPS-8.
C. Configure FSPF link costs on the MDS switch.
D. Configure QoS on the MDS switch.

Correct Answer: C Section: (none)Explanation Explanation/Reference:
QUESTION 73
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
A. 8
B. 16
C. 24
D. 32

Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 74
What two commands must be executed on an MDS 9000 family switch in order to change a dynamically assigned Domain ID 5 to a static Domain ID 10 for VSAN 10? Choose two.
A. switch(config-if)# shut fcdomain 5
B. switch(config-if)# no shut fcdomain 10
C. switch(config)# fcdomain domain 10
D. switch(config)# fcdomain domain 10 static vsan 10
E. switch(config)# fcdomain restart vsan 10
F. switch(config)# fcdomain restart disruptive vsan 10

Correct Answer: DF Section: (none)Explanation
Explanation/Reference:
QUESTION 75
You have been asked to configure a port on your Cisco MDS switch so that a host can join your fabric. Which of these switch port types should the port be set to?
A. N_Port
B. NL_Port
C. F_Port
D. E_Port
E. TE_Port
F. SD_Port

Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 76
The MDS 9000 family switches use what three technologies to protect against unauthorized management access? (Choose three.)
A. SNMPv3
B. SSH
C. RBAC
D. RMON
E. SES
F. WEBM

Correct Answer: ABC Section: (none)Explanation
Explanation/Reference:
QUESTION 77
Drop

A.
B.
C.
D.

Correct Answer: Section: (none)Explanation
Explanation/Reference:
Answer: Check certifyme eEngine, Download from Member Center
QUESTION 78
The HBA on your storage server only supports the NL_Port mode. Which interface type on the Cisco MDS 9000 Series fabric switches can support this HBA?
A. F
B. TE
C. FL
D. N
E. E

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 79
In order to allow access to a switch using Telnet, which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0? (Choose three.)
A. assign an admin password
B. accept auto for the switchport trunk mode
C. configure the IP address for the VSAN 1 interface
D. configure the netmask for the IP address
E. configure the IP address for the Mgmt0 interface
F. Configure SSH with an RSA1 key

Correct Answer: ADE Section: (none) Explanation
Explanation/Reference:
QUESTION 80
Which three of these terms are valid Fibre Channel topologies? (Choose three.)
A. point-to-point
B. switched backbone
C. Gigabit Ethernet
D. arbitrated loop
E. switched fabric
F. autonomous region

Correct Answer: ADE Section: (none)Explanation
Explanation/Reference:
QUESTION 81
You have been asked to configure a port on your Cisco MDS switch so that a host can join your fabric. Which of these switch port types should the port be set to?
A. N_Port
B. NL_Port
C. F_Port
D. E_Port
E. TE_Port
F. SD_Port

Correct Answer: C Section: (none)Explanation Explanation/Reference:
QUESTION 82
The MDS 9000 family switches use what three technologies to protect against unauthorized management access? (Choose three.)
A. SNMPv3
B. SSH
C. RBAC
D. RMON
E. SES
F. WEBM

Correct Answer: ABC Section: (none) Explanation
Explanation/Reference:
QUESTION 83
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?
A. Configure OSPF routing on the IPS-8.
B. Configure EIGRP routing on the IPS-8.
C. Configure FSPF link costs on the MDS switch.
D. Configure QoS on the MDS switch.

Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 84
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?
A. VSAN capabilities were not enabled.
B. Default switchport trunk mode was set to auto.
C. Full zoneset distribution was not enabled.
D. Default switchport trunk mode was set to on.

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 85
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
B. 16
C. 24
D. 32

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 86
While examining the output of a show run command on the Cisco MDS 9000 Series, you notice that the statement interface GigabitEthernet2/1.2 appears in the output. What does this mean?
A. It refers to the second FCIP tunnel that is configured on port GigabitEthernet2/1.
B. It refers to a VLAN subinterface on port GigabitEthernet2/1.
C. It means that port GigabitEthernet2/1 is assigned to VSAN 2.
D. It is a mistake in the interface configuration.

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 87
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?
A. Configure OSPF routing on the IPS-8.
B. Configure EIGRP routing on the IPS-8.
C. Configure FSPF link costs on the MDS switch.
D. Configure QoS on the MDS switch.

Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 88
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?
A. VSAN capabilities were not enabled.
B. Default switchport trunk mode was set to auto.
C. Full zoneset distribution was not enabled.
D. Default switchport trunk mode was set to on.

Correct Answer: B Section: (none) Explanation
Explanation/Reference: QUESTION 89
What information does the command show flogi database provide?
A. verifies connectivity for attached devices
B. verifies that attached devices are in the correct zone
C. displays a list of the host ports that have logged into each storage port
D. displays fabric login errors

Correct Answer: A Section: (none)Explanation
Explanation/Reference:
QUESTION 90
What two commands must be executed on an MDS 9000 family switch in order to change a dynamically assigned Domain ID 5 to a static Domain ID 10 for VSAN 10? Choose two.
A. switch(config-if)# shut fcdomain 5
B. switch(config-if)# no shut fcdomain 10
C. switch(config)# fcdomain domain 10
D. switch(config)# fcdomain domain 10 static vsan 10
E. switch(config)# fcdomain restart vsan 10
F. switch(config)# fcdomain restart disruptive vsan 10

Correct Answer: DF Section: (none)Explanation
Explanation/Reference:

Flydumps expert team take advantage of their experience and knowledge to continue to enhance the quality of Cisco 642-355 exam training materials to meet the needs of the candidates and guarantee the candidates to pass Cisco 642-355 exam which is they first time to participate in. Through purchasing Flydumps products, you can always get faster updates and more accurate information about the examination. And Flydumps provide a wide coverage of the content of the Cisco 642-355 exam and convenience for many of the candidates participating in the IT certification Cisco 642-355 exams except the accuracy rate of 100%. It can give you 100% confidence and make you feel at ease to take the Cisco 642-355 exam.

Welcome to download the newest Pass4itsure 300-320 dumps: http://www.pass4itsure.com/300-320.html

http://www.alnaba.org/hp-hp2-b120-questions-offer-hp-hp2-b120-study-material-online-store/